STEALTH STUD USB DRIVER
Downloading USB Drivers for the TRAX Stealth Stud USB Radio Module
The TRAX Stealth Stud communicates with your computer via the USB Radio Module. This radio module requires USB drivers to run properly.
IMPORTANT: Note that these drivers are automatically available through the Windows Update web site when you first connect the USB Radio Module. This is the recommended method for installing the drivers. However, if you have trouble installing the drivers automatically, they can be installed manually by first downloading the driver file below.
The file you will be downloading is USB driver for TRAX Stealth Stud Radio Module.zip. This is a zip file that contains all the file necessary to load the USB drivers for the USB Radio Module.
To download the file, click on the Download button below. When the File Download screen appears, select Save and make note of where the file is being saved. Once the file is downloaded, double-click on it and unzip the files to a folder on your computer. Make a note as to which folder the files have been unzipped.
​
​
​
​
Firmware Downloads for the TRAX Stealth Stud
Installation Instructions
To install the new firmware, download the file to your computer, then unzip it, making a note of the folder you have unzipped it to. Next, run the software you use to connect to your studs (MLink-S or TRAXPro) and use it to upload the new firmware.
​
Current: Version 1.4.1832 - Released March 2014
This version continues improvements against instances where RF interference could cause the radio module to enter a continuous loop, leading to a communications lock-up.
​
​
Previous: Version 1.4.1767 - Released September 2013
This version corrects a problem where RF interference could cause the radio module to enter a continuous loop, leading to a communications lock-up and draining the stud battery.
Version 1.3.1736 - Released April 2013
This version modifies the battery level monitoring of the stud to help prevent the battery from draining to the point where it cannot recharge.